Sun V210/240 System Board w/ 2 x 1Ghz CPU'sSun Part Number 375-3150 2 x Sun UltraSPARC 1Ghz CPU's Sun Original Product
| LOCATION | PINS | SETTING | DESCRIPTION |
|---|
| JP1 | 1-2
3-4
9-10 | In
In
In | 1.4V Core VID[4:0] Bit 4 (00110)
1.4V Core VID[4:0] Bit 3 (00110)
1.4V Core VID[4:0] Bit 0 (00110) | | JP2 | 1-2
1-2 | Out
In | ALOM Flash Normal (default)
ALOM Flash Recovery | | JP3 | 1-2
1-2 | Out
In | ALOM Normal (default)
ALOM Reset | | JP4 | 1-2 | In | 1.002GHz CONFIG[2:0] Bit 0 (110) | 1-2
3-4 | In
In | 1.280GHz CONFIG[2:0] Bit 0 (100)
1.280GHz CONFIG[2:0] Bit 1 (100) | | 5-6 | In | 1.336GHz CONFIG[2:0] Bit 2 (011) | 1-2
5-6 | In
In | 1.503GHz CONFIG[2:0] Bit 0 (010)
1.503GHz CONFIG[2:0] Bit 2 (010) | | JP5 | 1-2
1-2 | Out
In | ATAPI Master - CSEL Open (default)
ATAPI Slave - CSEL Grounded | | JP6 | 1-2
2-3 | In/Out
In | OBP Flash Select (default)
ROMBO Select | | JP8 | 1-2
2-3 | In
In | Normal CMOS (default)
Clear CMOS | | JP10 | 1-2
1-2 | Out
In | Normal PS_ON# (default)
PS_ON# Override | | JP11 | 1-2
1-2 | Out
In | OBP Flash Write Enabled (default)
OBP Flash Write Protected | | JP12 | 1-2
1-2 | Out
In | ALOM Console Normal (default)
ALOM Console Bypass | | JP13 | 1-2
2-3 | In/Out
In | OBP Flash Normal (default)
OBP Flash Recovery |
Device Paths| PCI Card Slots: | 0 | 33/66MHz | /pci@1d,700000/<device>@1 | | 1 (V240 only) | 33MHz | /pci@1e,600000/<device>@3 | | 2 (V240 only) | 33MHz | /pci@1e,600000/<device>@2 | Onboard Gigabit
Ethernet Ports: | BGE0 | /pci@1f,700000/network@2 | | BGE1 | /pci@1f,700000/network@2,1 | | BGE2 | /pci@1d,700000/network@2 | | BGE3 | /pci@1d,700000/network@2,1 | Internal SCSI
Hard Drives: | Target 0 | /pci@1c,600000/scsi@2/sd@0 | | Target 1 | /pci@1c,600000/scsi@2/sd@1 | | Target 2 (V240 only) | /pci@1c,600000/scsi@2/sd@2 | | Target 3 (V240 only) | /pci@1c,600000/scsi@2/sd@3 | | External SCSI Port: | /pci@1c,600000/scsi@2,1 | | IDE Controller (for DVD-ROM): | /pci@1e,600000/ide@d | | USB Controller: | /pci@1e,600000/usb@a | | Serial Port Controller: | /pci@1e,600000/serial@0 | | Environmental Bus (I2C): | /pci@1e,600000/i2c@0 | | System/ALOM Comm: | /pci@1e,600000/isa@7/rmc-comm@0 |
Notes- The minimum operating system for 1.002GHz and 1.280GHz is Solaris 8 12/02.
The minimum operating system for 1.336GHz and 1.503GHz is Solaris 8 7/03 with patch 109885-15 or later, Solaris 9 12/03, or Solaris 10. - ALOM update is available at Firmware Downloads.
- The JBUS clock is 167MHz and the Memory clock is 111.33MHz with 1.002GHz CPUs.
- The JBUS clock is 160MHz and the Memory clock is 128MHz with 1.280GHz CPUs.
- The JBUS clock is 167MHz and the Memory clock is 111MHz with 1.336GHz CPUs.
- The JBUS clock is 167MHz and the Memory clock is 125MHz with 1.503GHz CPUs.
Memory Notes- Bank, Rank, DIMM, and XOR Interleaving is supported.
- UltraSPARC IIIi supports single bank and dual bank DDR DIMMs.
- Two DIMMs of the same bank size (single or dual) and memory size form a bank.
- The minimum requirement is two DIMMs in any Bank (B0/D0/D1 or B1/D0/D1).
- Only CPU 0 DIMMs are accessible in a single CPU system (CPU 0).
- Memory is mapped globally and is accessible by either CPU in a dual-CPU system.
- Memory error reporting identifies a failing Bank, not a single failing DIMM.
Motherboard Notes- The DB9 IOIOI serial port requires an EMI gasket.
- Motherboards 375-3107, 375-3148, 375-3246, 375-3297, 375-3228, 375-3325, and 375-3459 are without Memory or UltraSPARC IIIi.
- Motherboard FRUs include Motherboard assembly, US IIIi, and Fan/Heatsink.
Part numbers are shown in subheaders above. - Fan/Heatsink FRU F370-5126 includes Fan 370-5126 or 370-7786.
- Fan/Heatsink 370-5126 is not qualified for use with Motherboard 375-3228.
- Fan/Heatsink 370-7016 is not available as a FRU.
- Fan/Heatsink 371-0831 became a secondary source in assemblies using 370-5126, 370-7016, or 370-7786 in February 2006.
- Motherboard replacement requires a 3/16 Hex driver, #2 Phillips driver, and a Slotted driver with a maximum thickness of 0.660 mm (0.026").
- An alternate source for the AMD 29F016 Flash PROM was added in November 2004.
The Macronix 29F016 Flash PROM requires OBP 4.13v2 and ALOM 1.4. - The procedure for replacing the heatsink on V210 and V240 with >= 1.5GHz CPU speeds has changed.
Sun original product.
All items tested by our experienced team of technicians and pulled from working systems. Item is refurbished with 90 days warranty, extended warranty options available.
Sameday and next day delivery available.
|