Notes

1. The minimum operating system is Solaris 2.5.1.
2. OBP 3.11 is required if Solaris 2.7 is used in 64-bit mode.
3. The flash PROM is soldered to the system board.
4. Use the Flash PROM Programming Utility to update the flash PROM.

Graphics Notes

1. FFB2+ is not compatible with 300MHz Module 501-4196.
2. FFB2+ is not compatible with 300MHz Module <=501-4849-02.
3. Elite3D is not compatible with 300MHz Module 501-4196.
4. Elite3D is not compatible with 300MHz Module <=501-4849-02.

Memory Notes

1. Two pairs of SIMMs form a Group.
2. All four SIMMs within a Group must be the same size.
3. The minimum memory requirement is four SIMMs in Group 0.
4. SIMMs can be installed in Group 1, Group 2, or Group 3 in any order.
5. A Group addresses 512MB of memory. Unused memory is mapped out.
6. OBP <= 3.1.3 reports memory errors as a pair of SIMMs.
7. OBP <= 3.1.3 reports the wrong SIMM pair when a memory error occurs.
8. OBP 3.1.5 reports memory errors as a single SIMM.

Internal SCSI Bus Notes

1. The SCSI controller is connected to J1202, J3201, and J3202.
2. There is no termination at J1202, J3201, or J3202.
3. The internal SCSI bus is terminated at J1203.
4. Connect J1202 to J1203 with cable 530-1451 or CD-ROM/Tape Drive cable 530-2137 to terminate the internal SCSI bus.